DK Digital RSU-150 Betriebsanleitung PDF herunterladen

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader

Tel 800.624.5625 [email protected]

in door opening solutions

Page 1 Rev. C, 04/11

SECURITRON MODEL DK-12 DIGITAL KEYPAD

INSTALLATION & OPERATING INSTRUCTIONS

1. SPECIFICATIONS

MECHANICAL ELECTRICAL/ENVIRONMENTAL

Keypad Dimensions:

2” x 2-3/4” x 1/4” (Width x Length x Height

off of stainless steel faceplate)

Stainless Steel Faceplate Dimensions:

2-3/4” x 4-7/16” x 5/32” (Width x Length x

Height)

Back Board Dimensions:

1-29/32” x 2-13/16” x 1-1/16” (Width x

Length x Height off of stainless steel

faceplate)

Power Supply:

12/24VDC @ 100 milliamps maximum

12/24VAC @ 325 milliamps maximum

Relay Contacts:

Maximum 5 amps @ 30 volts

Environmental:

Operating: -10°F [-23°C] to 140°F [60°C]

Storage: -10°F [-23°C] to 150°F [65.6°C]

Humidity: 0% to 95% RH

2. INSTALLATION

SURFACE MOUNT WALL BOX

 Separate the wall box cover and base.

 Remove rectangular knockout in the center of the base.

 Cut out opening in the wall that will be used to route the wires through.

 Mount base to wall over wire opening using the #6 sheet metal screws and plastic anchors.

 Mount DK-12 to cover with either tamper resistant #6 screws (recommended) or #6

conventional screws. See Section 7 (Programming) before securing DK-12 in place.

 Pull wires through wall/center of base and connect to DK-12 wiring terminals (see Section 3

for wiring instructions).

 Push the wall box cover onto the base until it snaps into place.

FLUSH MOUNT WALL BOX

 Cut out opening in wall to mount box into.

 Route wiring through one of the four knockouts in the back of the box.

 Push the box into the wall and secure in place using the two swing clamps.

 Connect wires to DK-12 wiring terminals (see Section 3 for wiring instructions).

 Mount DK-12 to box with either tamper resistant #6 screws (recommended) or #6

conventional screws. See Section 7 (Programming) before securing DK-12 in place.

The DK-12 can be used outdoors with the optional rain cover (Securitron part #WCC) which will

allow the DK-12 to be mounted in outdoor locations not directly exposed to rain or snow. When

used outdoors you must supply a weatherproof, gasketed wall box (available from Securitron

under part #WBB).

3. WIRING

Wiring Terminal Connections

1. ‘AC/DC+’ One AC supply lead or positive DC supply lead.

2. ‘AC/DC-’ Other AC supply lead or negative DC supply lead.

3. ‘NC’ Normally closed relay contact.

4. ‘COM’ Common for relay contacts.

5. ‘NO’ Normally open relay contact.

6. ‘SRC’ Supply for REX signal.

7. ‘REX’ REX Signal input.

NOTE: Each terminal is provided with a marking in front of it for

easy reference.

DK-12

Back Side

Wiring

Terminals

AC/DC+

AC/DC-

COM

SRC

REX

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader Tel 800.624.5625 [email protected] in door opening solution

Seite 2 - Page 2 Rev. C, 04/11

PN# 500-24010 Page 2 Rev. C, 04/11 Basic Power and Electric Lock Connections:  Connect supply to ‘AC/DC+’ and ‘AC/DC-’ terminals.  Connect

Seite 3 - Page 3 Rev. C, 04/11

PN# 500-24010 Page 3 Rev. C, 04/11 Double Break Wiring For Free Egress (SPDT):  Connect DC supply to ‘AC/DC+’ and ‘AC/DC-’ terminals.  Con

Seite 4 - Page 4 Rev. C, 04/11

PN# 500-24010 Page 4 Rev. C, 04/11 INDICATOR ACTION MEANING Green Light Continuously On While in normal mode a 30-Second lockout occurred afte

Seite 5

PN# 500-24010 Page 5 Rev. C, 04/11 Setting/Changing Codes:  Enter program code on the keypad.  Press either ‘#’ or ‘’ and the yellow ligh

Seite 6 - Page 6 Rev. C, 04/11

PN# 500-24010 Page 6 Rev. C, 04/11 As delivered the DK-12 echoes key presses by a short flash of the green light. The red light flashes once p

Seite 7 - Page 7 Rev. C, 04/11

PN# 500-24010 Page 7 Rev. C, 04/11 energize automatically after that timer period expires. The default time is 5 seconds but it can be changed

Seite 8 - Page 8 Rev. C, 04/11

PN# 500-24010 Page 8 Rev. C, 04/11 occur if a user code was a subset of the program code. The unit could not be put into programming mode from

Weitere Dokumente für Wecker DK Digital RSU-150

Um das Dokument anzuzeigen DK Digital RSU-150 Bedienungsanleitung

DK Digital RSU-150 Bedienungsanleitung (38 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

DK Digital RSU-150 Betriebsanleitung

Stöbern Sie online oder laden Sie Betriebsanleitung nach Wecker DK Digital RSU-150 herunter. DK Digital RSU-150 Operating instructions Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Wecker DK Digital RSU-150

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wecker DK Digital RSU-150